KCD-300
Industrial 10/100Base-TX to
100Base-FX Media Converters
The industrial KCD-300 media converter series provides industrial strength Ethernet copper-to-fiber
media conversion, allowing for 10Base-T-100Base-FX or 100Base-TX-100Base-FX over multi-mode
or optional single-mode fiber optical media.
Benefits :
Comprehensive configuration settings to increase flexibility for application needs
Wide operating temperature range for temperature critical environment
Support DIN rail mounting and panel mounting
Provide two power input types to meet more application needs
Accept wide power input voltage range for application flexibility
Industrial-rated Emission and Immunity performance
DIN Rail Mounting Bracket
Key Features :
Support full wire speed conversion for 10/100 speed and media types
Support auto-negotiation 10/100Mbps or forced mode on TP copper port
Auto MDI/MDI-X crossover function on the TP copper port
Provide Link Fault Pass Through function
Provide comprehensive manual configuration settings
Transparent conversion to 802.1Q VLAN tagged packets
Provides Far End Fault function on FX (fiber) port
Low power consumption
Two power interface types: screw terminal block and DC Jack
Supports wide power input voltage range
Supports DIN rail mounting and optional screwed plane mounting
Supports wide operating temperature range
Industrial-rated Emission and Immunity performance
Panel Mounting Bracket
Specifications :
Conversion
10BASE-T to 100BASE-FX
100BASE-TX to 100BASE-FX
Conversion Methods Smart-forward mode :
- Store-and-forward for 10M to 100M
- Direct conversion for 100M to 100M
Store-and-forward always mode
Packet Types
TP Port
Transparent conversion with no modification to :
- Standard IEEE 802.3 Ethernet packet frames
- IEEE 802.1Q tagged packet frames
Shielded RJ-45 jack
Auto MDI/MDI-X crossover function
Auto-negotiation function for speed and duplex mode
Full-duplex and half-duplex support
10Mbps - supports Cat. 3,4,5 UTP cable up to 100m
100Mbps - supports Cat. 5 UTP cable up to 100m
080110
|