LEGACY®
OWNER’S MANUAL
LCD36
MANUALLY TUNED STEREO RADIO WITH
COMPACT DISC PLAYER DIGITAL
INSTALLATION
Here is the installation diagram.
DASH BOARD
HEX NUT
METAL MOUNTING STRAP
SPRING
WASHER
TAPPING
SCREW
HEX BOLT
PLAIN WASHER
CONSOLE
MOUNTING HOUSING
Precautions
1. Choose the mounting location where the
unit will not interfere with the normal
driving functions of the driver.
Fire Wall
2. Avoid installing the unit where it would
be subject to high temperature, such as
from direct sunlight, or from hot air, from
the heater, or where it would be subject
to dust, dirt or excessive vibration.
3. For safe installation, use the mounting
hardware provided by the manufacturer.
Bracket
3
REMOVE THE UNIT FROM THE DASH BOARD
1. Remove the metal strap attached to the back of the unit.
2. Disconnect all the wires of the unit and the antenna plug.
3. Remove the handle frame from the trim plate.
4. Insert the screw driver into the slot as shown, and slide the unit out of the dash
board while holding the trim plate.
5. Remove the screw driver from the slot.
SLOT
SLEEVE
SCREW DRIVER
TRIM
PLATE
HANDLE FRAME
4
OPERATION
3
5
13
16
7
12
1
4
18 14 15
11
10
9
6
2
17 8
GENERAL OPERATION
• ON/OFF
Press POWWR button (1) to turn on the unit. Press it again to turn it off.
• BALANCE
Rotate the button (2) clockwise or anti-clockwise to adjust sound balance between
left and right speakers.
• VOLUME
Rotate the button (3) clockwise or anti-clockwise to adjust volume level.
• TONE CONTROL
Rotate the button (4) clockwise or anti-clockwise to obtain the desired sound
quality.
• SELECT MODE
Press MOD button (5) to change radio or CD mode.
• LIQUID CRYSTAL DISPLAY
The LCD (16) can show the current state of the unit.
• RESET BUTTON FUNCTION
RESET button (17) is placed on the housing and must be activated with either a
ballpoint pen or thin metal object. The RESET button (17) is to be activated for the
following reasons:
- Initial installation of the unit when all wiring is completed.
- All the function buttons do not operate.
- Error symbol on the display.
5
RADIO OPERATION
• BAND
Press BND button (7) to change bands as below:
FM
AM
• SELECT STATION
Rotate the TUNING knob (8) clockwise or anti-clockwise to adjust the frequency
upward or downward.
• LOCAL/DISTANT
Press the LOC/RPT button (9) to select between local setting for reception of
strong station and distant setting for reception of weak stations when tuning.
• MONO/STEREO
In FM band, press MON/INT button (10) to select mono or stereo reception for
radio stations. You can sometimes improve reception of distant stations by selecting
mono operation.
6
CD OPERATION
• DISC PLAY
Gently insert a compact disc with the label side facing up into the disc slot (13).
The disc is then automatically loaded into the unit and starts playing with the first
track of the disc. The digital display will indicate the track number and the time of
the track.
• EJECT
Press (eject) button (12) to stop CD play and eject CD from the slot. Receiver
switches to radio operation.
• PAUSE CD
During CD playing, press
button (11) to temporarily stop playing.
Press it again to resume playback.
• SKIP TRACKS
Press
button (15) or
button (14) to choose the following track or the
previous track. Track numbers show on the display.
• FAST FORWARD AND FAST REVERSE
Hold
button (15) or
button (14) for several seconds to fast forward or fast
reverse. Releasing the button to stop fast playing.
• REPEAT
During CD operation, press LOC/RPT button (9) to continuously repeat playing the
current track. Press it again to release the mode.
• INTRO: PREVIEW ALL TRACKS
During CD operation, press MON/INT button (10) to play first several seconds of
each track. Press it again to stop intro and listen to track.
• RANDOM: PLAY ALL TRACKS IN THE RANDOM ORDER
During CD operation, press and hold RND button (6) for several seconds to play
all tracks in the random order. Press it again to cancel the function.
• MUT (MUTE)
Press the MUT button (18) to cut down the sound output and LCD display will
indicate “MUTE”. Press it again to release the mode and recover the previous
volume level.
7
WIRING CONNECTION
MAIN UNIT
ANTENNA CONNECTOR
RCA CABLE
Rch RED
POWER
ANTENNA
BLUE
FUSE
Lch WHITE
RED
IGNITION
B(+)
WHITE
GREY
LEFT
RIGHT
SPEAKER
SPEAKER
BLACK
GROUND/SPK.COMMON
SPECIFICATION
General
Power Supply Requirements
Chassis Dimensions
: DC 12 Volts, Negative Ground
: 178 (W) x 163 (D) x 51 (H) mm
: 7 W X 2
Maximum Output Power
CD Player
Signal to Noise Ratio
Channel Separation
Frequency Response
: More than 60 dB
: More than 60 dB
: 100 Hz - 15 KHz
Radio Section
FM
Frequency Range
: 88 MHz – 108 MHz
: 10.7 MHz
: Better than 25 dBu
: More than 24 dB
AM
Intermediate Frequency
Usable Sensitivity (Mono)
Stereo Separation at 1 KHz
Frequency Range
Intermediate Frequency
Usable Sensitivity (S/N 20 dB)
: 530 KHz – 1710 KHz
: 455 KHz
: Better than 42 dBu
88-C2072-09
|