LUNA
dome
kettle
1.8L Capacity
360° Cordless
kettle base
y
Brushed stainless
steel body
Model:
22362B
1800W
from the wall socket when it is
not in use.
this kettle.
13.Only use the base unit supplied
with this product. If a replacement is
required only approved components
must be used.
Before Use
1. Read these instructions carefully
with the illustrations before using the
appliance for the first time.
Operating Instructions
2. Before connecting the kettle, check
that the voltage indicated on the
rating label (underneath of base)
corresponds with the mains voltage in
your home.
3. The kettle will switch off automatically
when the water has boiled. You can
switch the kettle off manually before
boiling by using the switch.
1. Make sure that the filter is pressed into
the holes of the lid tongue and fitted
correctly.
2. Fill the water into the kettle making
sure that the water capacity is not
lower than the “MIN” mark and does
not exceed the “MAX“ mark.
3. Ensure the lid is closed properly.
4. Insert plug into wall socket.
4. After the kettle has switched off
automatically (or has been switched
off manually) it will need some time to
cool down. After 15-20 seconds, the
kettle can be switched on again.
5. The kettle is protected against dry-
boiling. This happens when the kettle
is switched on with insufficient water.
The kettle will switch off by means of
a safety cut out switch to prevent the
element from over heating.
6. If the kettle runs dry while operating,
allow to cool down for 15 minutes
before refilling with cold water. The
safety cut-out will automatically reset.
7. Place the appliance on a stable, flat
surface. Ensure that the kettle cannot
fall into water.
5. Put the kettle body onto the base.
6. Switch the appliance on, making sure
that the indicator light is illuminated.
7. When the water is boiled, the appliance
will automatically switch off and the
indicator light will switch off.
8. If the water has to be reheated, please
wait several minutes before reboiling.
Cleaning Instructions:
Always disconnect the kettle from the wall
socket when cleaning.
A. Kettle Body Cleaning:
Scaling or furring up is a common
problem. A water purifier and periodic
cleaning is recommended.
Scaling will damage the function of the
heating element and impair the function
of the dry boil protector.
• To clean the inside of the kettle, fill with
water, then add 200ml of white vinegar
and let the mixture boil.
8. Never immerse the kettle in water.
Do not allow water to penetrate the
electrical parts inside the kettle.
9. Prevent children from pulling the power
cord, or knocking
the kettle over.
10.Before cleaning the kettle, make sure
• Unplug the appliance, pour
away this mixture.
the kettle is disconnected from the wall • Re-clean at least three times with water
socket and that it
to remove the particles.
has cooled down.
11.The kettle may be cleaned with a
damp cloth.
B. Filter Cleaning:
• Take out and place the filter under a tap
and rub gently with your fingers.
12.Discard the very first water boiled from
• Be careful not to use anything that will
tear the filter when cleaning.
• b. Dip in a proprietary descaling agent
and rub gently then rinse.
Specification
Voltage:220-240V 50Hz
Power:1850-2200W
Capacity:1.8 L
• c. Descale your filter at regular intervals
in order not to impair the pouring
• performance of your kettle.
22362B_
|